A trace computed two ways
A computes the of one in two ways and equates the results. In Masullo's proof one computation gives a sum over the zeros of an and the other gives a sum over . This chapter works the simplest example, from the paper's introduction, where both sides can be computed directly.
Based on the toy example in the paper's introduction (pages 11–33), which I read in full. The lab computes both sides numerically; the file RH/Toy.lean states the identity and proves one consequence from it.
The circle modulo
Fix and identify with for every . In the coordinate this is the real line : a circle of circumference . Lengths on it are measured by .
Fix a smooth function on that is zero outside a bounded interval away from 0 (a ). It defines a on functions on the circle:
Each value of is replaced by a -weighted average of its values at rescaled points.
is linear, and its trace is the sum of its . The trace can be computed in two ways. Both use the , .
- From the eigenvalues (the ). The function is well defined on the circle exactly when , that is, for an integer . These are the of the circle. Substituting into the definition gives , so each mode is an with eigenvalue . The trace is the sum of these over all .
- From the (the geometric side). Written as an over one turn of the circle, with , one term for each number of times around. The trace of an integral operator is the integral of its kernel along the diagonal . There , a constant, and the circle has length .
Both sums run over all integers. In the coordinate this is the formula.
How the example corresponds to the paper
In the paper the circle is replaced by a much larger group, built from all the of a , and the operator is again convolution with a test function . The two sides of the trace become:
- spectral side: one term for each zero of the L-function, in place of one term for each mode;
- geometric side: each prime contributes like a circle of circumference , giving terms at the .
The resulting identity, a sum over zeros equal to a sum over prime powers for every test function , is a form of the of chapter 8.
When the trace is zero
If is zero outside an interval strictly between 1 and , then for every integer . The geometric side is 0, so the sum of the eigenvalues is 0, although the individual eigenvalues are not. The paper uses this to remove all but finitely many primes: for a fixed , every prime larger than the right end of the interval where is nonzero contributes 0.
In Lean
The repository states the identity and proves from it that the trace is zero in the case above. The identity itself is still a sorry; has summation, and deriving this form from it is the next Lean task.
theorem trace_identity {γ : ℝ} (hγ : 1 < γ) {φ : ℝ → ℂ}
(hφ : ContDiff ℝ ∞ φ) (hc : HasCompactSupport φ) (h0 : tsupport φ ⊆ Ioi 0) :
∑' m : ℤ, mellin φ (2 * π * Complex.I * m / Real.log γ)
= Real.log γ * ∑' k : ℤ, φ (γ ^ k) := by sorry
theorem trace_eq_zero … (hs : tsupport φ ⊆ Ioo 1 γ) :
∑' m : ℤ, mellin φ (2 * π * Complex.I * m / Real.log γ) = 0
Things to try
- Move the bump center until the bump lies between the dashed lines at 1 and . Both sides become 0. Then lower to 1 or 2: the partial sums are not 0, only the full sum is.
- Make the bump wide enough to cover two powers of . The geometric side counts both.
- Shrink toward 1.3. More powers of fall inside the bump and the trace grows.
Exercises
- Check that .
Solution
- Why is a function on the circle only when ?
Solution
On the circle and are the same point, so a function must take the same value at both. , which equals exactly when , that is, .
- Take and a test function that is zero outside the interval . Write down the geometric side.
Solution
The powers of 3 inside are 3 and 9. The trace is .
Check your understanding
For supported inside the trace is 0, yet the eigenvalue of the constant mode, , is positive. How can both be true?
- The other eigenvalues are complex numbers with varying phases, and together they cancel it exactly
- The other eigenvalues are all 0
- The trace formula fails for such
The trace is the sum of all eigenvalues, not a statement about each one. That an infinite sum of nonzero terms must total exactly 0 is real information about where the modes are.
Where does the term on the geometric side come from?
- From the -th eigenvalue
- On the circle, and are the same point, so the kernel on the diagonal collects once for each way of going round times
- From the -th derivative of
: the operator moves a point by the factor with weight , and it returns to where it started exactly when is a power of .
Replace by . What happens to the two sides?
- Nothing changes
- The modes move twice as far apart, and all powers of 2 still appear
- The modes become twice as dense, and only the even powers of 2 appear, each with weight ln 4
Modes sit at , and halves the spacing. The geometric side is . A longer circle has more modes and fewer returns.